MTD 241-675-000 - Manual (Page 3)

ASSEMBLY INSTRUCTIONS
IMPORTANT: This unit is shipped WITHOUT
GASOLINE or OIL. After assembly, service engine
with gasoline and oil as instructed in the separate
engine manual packed with your unit.
NOTE: Reference to right or left hand side of the
vacuum is observed from behind the unit in the
operating position.
B—
FIGURE 1.
N
Q----- ^(5=
FIGURE 2.
FIGURE 3.
Belleville
Washer (G),
Hand
Knob (F
Nozzle (N)y-y
FIGURE 4.
CONTENTS OF HARDWARE PACK
(See Figure 1)
A (1) Clutch Grip Assembly*
(1) Hairpin Clip*
(1) Clevis Pin*
(1) Extension Spring*
(1) Lock Nut 1/4-20 Thread*
(3) Hand Knobs
(3) Belleville Washers
(4) Hex Bolt 1/4-20 x 1.75" Long
(4) Hex Lock Nuts 1/4-20 Thread
(2) Stud Pins
(2) Push-On Speed Nuts
(1) Hex Jam Nut 1/4-20 Thread* B
C
D
E
F
G
I
-J
K
L
M
| n | 0 0 5
‘Self-Propelled Models Only.
LOOSE PARTS IN CARTON
(See Figure 2)
N (1) Nozzle
Upper Handle
Air Duct Assembly
(1) Clutch Rod (Self-Propelled Models Only)
(1) Directional Discharge Assembly
Impeller Guard
Bag
O
P
Q
R
S
T
( 1 )
(1)
( 1 )
( 1 )
TOW BAR KIT
Standard for push models, optional for self-
propelled models.
(See Figure 3)
U (2) Hex Bolts 5/16-18 x 1.00" Long
(4) Shoulder Spacers
(2) Hex Nut 5/16-18 Thread
(1) Truss Machine Screw 1/4-20 x .75" Long
(1) Lock Washer 1/4" I.D.
(1) Hex Nut 1/4-20 Thread
AA (1) Shoulder Bolt
Belleville Washers 3/8" I.D.
Hex Jam Lock Nut 3/8-16 Thread
(2) Tow Bar Halves (Not Shown)
V
W
X
Y
Z
AB (2)
AC (1)
ATTACHING THE NOZZLE
Place nozzle (N) in position on front of housing so that
it rests in flanges. Secure with one hand knob (F) and
belleville washer (G) (cupped side of washer against
-the nozzle). See figure 4.