Citizen Systems iDP-3423 - Manual (Page 9)

iDP-3420/3421/3423 User’s Manual
9 CITIZEN
P PP PRE RE RE REC C C CA A A AU U U UT TT TIIIIO O O ON N N NS S S S F FF FO O O OR R R R IIIIN N N NSSSST TT TA A A ALL LL LL LLA A A AT TT TIIIIO O O ON N N N
· Do not use or store the equipment in a place exposed to fire, moisture, or direct sunlight, or
in a place near a heater or a thermal device where the prescribed operating temperature
and humidity are not met, or in a place exposed to much oil, iron powder, or dust. The
equipment may become out of order, emit smoke, or catch fire.
· Do not install the equipment in a place like a laboratory where chemical reactions are
expected, or in a place where salt or gases are contained in the air. There is a danger of
fire or electric shock.
· Do not put any object on the printer. It may cause trouble.
· Do not use the equipment near a radio or TV receiver. Do not share the power from a plug
socket a radio or TV receiver is connected to. It may cause a reception problem.
· Use the equipment only at the specified voltage and frequency. Otherwise, it may emit
smoke and catch fire or cause other problems.
· Confirm that a plug socket used for connection has sufficient capacity.
· Do not overload a single electrical outlet in connecting the power cable. It may result in
the cable catching fire or a power outage. Also, do not stamp or put any object on the
cable.
· Never connect a grounding cable to a gas pipe. There is a danger of explosion. When
connecting or disconnecting the grounding cable, be sure to disconnect the power plug from
the plug socket.
· When connecting/disconnecting the cables, be sure to turn off the power first, including the
connected side, and then connect/disconnect them, holding a plug and a connector. Do not
pull or carry the equipment with a load applied to the cable.
· Connect a connector cable securely. If a reverse-polarity connection is made, internal
elements may be broken or a mating device may be adversely affected.
· Use a shielding wire or twisted pair wire for a signal line, in order to minimize noise effect.
Avoid connecting to a device that is likely to generate noise.
· When a drawer kick connector is provided, do not connect any device other than the
prescribed solenoid specifications. Negligence of this could cause trouble.
· Use the equipment in an environment where there is a plug socket near the main body and
you can easily disconnect the power plug from it, to shut off the power.
· When the equipment will not be used for a long period of time, unplug it.
· When transporting the equipment, remove the rolled paper from it.
· Install the equipment on a flat, stable desk in a well-ventilated place free from vibrations.
(Do not block the ventilation port.)