Ariens 932007 - Manual (Page 16)

ASSEMBLY & PRE-SERVICE
TIRE PRESSURE
Models 932004 and 932006 are equipped with pneumatic tires.
Adjust pressure to 12 to 20 PSI before operating. Tire pressure
of 20 PSI is recommended for use with tire chains.
REGISTRATION
Fill out pre-warranty registration card and mail to Ariens Com­
pany. Warranty will only be registered under the model and
serial number found on the serial number label (also stamped in­
to the frame of the unit). Add serial numbers in serial number
recording area of this manual.
DELIVERY
Using the Owner’s Manual as a guide, instruct the customer as
follows:
1. Instruct the customer on the operation of the Sno-Thro.
Emphasize safety and discuss the safety information in the
Owner’s Manual.
2. Advise customer to change oil in the engine crankcase
after the first two hours of operation.
3. Explain how to perform the recommended lubrication and^
periodic service.
4. Explain maintenance and adjustment instructions.
5. Demonstrate how to mount and dismount attachments.
6. Make certain the customer has his Owner’s Manual and
Engine Instructions.
7. Explain Ariens Warranty Policy. Fill out and return Ariens
Warranty Registration Card.
SERIAL NUMBER — SNO-THRO
(PLATE LOCATED ON REAR OF FRAME)
SERIAL NUMBER — ENGINE
(STAMPED INTO TOP OF ENGINE ABOVE RECOIL START)
A message to the Ariens customer...
Welcome to the world of Ariens equipment. We are pleased that you have selected Ariens and sincerely believe you have pur­
chased the best equipment available. The care you give your new Ariens equipment will greatly determine the satisfaction and ser­
vice life you will obtain from it. Use this manual and the engine manual supplied, as your guide. By observing the instructions and
suggestions in these manuals, your Ariens equipment will serve you well for many years.
Your Ariens dealer will be happy to supply any service or advice which may be required to keep your Ariens equipment operating at
peak efficiency. He stocks genuine Ariens parts and lubricants; manufactured with the same precision and skill as the original
equipment. His factory trained staff is kept well informed on the best methods of servicing Ariens equipment and is ready and able
to serve you. If engine repairs or services are required, they can be obtained from an Ariens dealer or from an authorized engine
manufacturer’s service station. If service is required, be prepared to supply the service person with the Model Number and Serial
Number of the equipment and the engine, as well as a full description of the problem encountered.
-
1 6
-