Ariens 927065 - Manual (Page 13)

Figure 6
1. Guide Arm
2. Rear Link
3. PTOBelt
4. Electric Clutch Connector
5. Mower Deck
6. Front Guide
Disconnect
Front Guide
Here
ton a level surface, with tires inflated to correct
jre, and mower lift lever in the middle position.
|ure7)
ling height should be within 1/4 in. (6.35
I side of mower deck.
[mower blade(s) in line with discharge chute,
re distance from bottom of mower blade to
jnd.
Icertain the key is off and the spark plug wire
1 By hand rotate the measured blade to
ssite side of the deck.
ION: Use gloves or wrap a rag over the
sharp edges of the blade to prevent injury.
jre the distance of the same blade edge on
I new side (side opposite the discharge chute) of
»deck.
ver deck if needed.
Mower Deck Shown From The Front
2. 3
1. Discharge Chute 3. Mower Blade
Opening 4. Cutting Height
2. Mower Deck 5. Ground
Figure 7
Adjust (Figure 8)
NOTE: Raise low side of mower deck half the mea­
sured distance between low and high side of mower
deck. Lower high side of mower deck half the mea­
sured distance between high and low side of mower
deck.
1. On low side: Turn trunnion nut clockwise several
turns.
2. On high side: Turn trunnion nut counterclockwise
several turns.
3. Check that mower deck is level.
1. Rear Guide
2. Trunnion Nut
Figure 8
4 - 1 3