Troy-Bilt 12065 - Manual (Page 8)

Section
Please carefully follo'-v the steps in
this Section to pioperiy assemble
your new machine. These steps wiil
not take very long and they wiii as­
sure you of having assembled your
machine correctly.
WARNING
To prevent personal injury or prop­
erty (lamacje. do not attempt to
start the engine until all assemlily
steps are complete and you have
read and understand the safety and
operating
instructions in this
Manual.
Tools Needed:
One 3/8" Open End or
Adjustable Wrench
Two 7/16" Open End or
Adjustable Wrenches
Two 9/16" Open End or
Adjustable Wrenches
Funnel (to add oil)
Rag (to clean up any
spilled oil)
Block of Wood (to support
liller v.'hen removing wheei)
Ruler (for belt tension check)
1. Package Inspection
Inspect carton and its contents
upon delivery for evidence of
damage.
If you find or suspect any damage,
contact the carrier (trucking com­
pany) immediately. Inform them
of the specific damage and that
you wish to file a claim. To pro­
tect your rights, be sure to put this
in writing to the carrier within 15
days after your machine arrives.
The carrier will let you know how
to proceed with your claim.
Please let us know if you need any
assistance with this matter.
.»y £r^'
1
si
FIG. 2-1. Place screw on fop of tem­
plate and measure distance between
bottom of screw head and tip of
screw.
2. Package Contents
NOTE: Wait until you have as­
sembled the handlebars before
moving the tiller off the shipping
platform.
Carefully unpack the carton and
check that you have received the
items listed below. If any items are
missing or damaged, please con­
tact us for replacements.
• Tiller/Engine Assembly
• Handlebar Support (see A, Fig.
2 - 2 ).
• Handlebar Assembly (see L,
Fig. 2-2).
• Handlebar Panel (see K, Fig.
2 - 2 ).
• Hardware bag - includes:
NOTE: Use screw length tem­
plate (Fig. 2-1) to identify screws.
• (1) Slotted hd. screw,
#10-24 X 2" long
• (6) Curved head screws,
5/16"-18x 1-1/2” long
• (1) Hex hd. screw,
l/4"-20x 1-1/4" long
• (2) Hex hd. screws,
3/8"-16x3/4" long
• (4) Hex hd. self-threading
screws, l/4"-20x 1/2" long
• (2) Flat washers, 3/8"
• (6) Split Lockwashers, 5/16"
• (1) Hex locknut, l/4"-20
• (6) Hex nuts, 5/16”-18
• (2) Hex locknuts, 3/8"-16
• (1) Cable spring
• (1) Cable bracket (see R,
Fig. 2-4).
IMPORTANT: Motor oil must
be added to the engine before it
is started! The oil fitting proce­
dure is exptained in Step 7.