Ariens 009-1648 - Manual (Page 25)

Mower Pitch
Proper blade pitch is when the blade tip, measured
from the bottom surface, is 1/8" to 1/4" lower at front of
mower pan than when same tip is at rear of mower pan
(Figure 14).
Front of Unit
TTTT
— 4
1. Cutting Edges
2. Ground Level
3. Front Blade Height
4. Rear Blade Height
Figure 14
To Adjust pitch loosen flange lock nuts and slide
adjusting tabs up or down to achieve proper pitch
(Figure 13).
Mower Height
Adjusting hanger hooks equally raises or lowers the
mower pan and changes cutting height.
To adjust:
1. Loosen upper nuts on hanger hooks and turn lower
nuts equally clockwise to lower or counterclockwise
to raise rear of rotary mower. With mower
attachment lift in highest position, front blade height
should measure 5" from ground level.
2. Secure hanger hooks by tightening nuts.
Mower Belt
The mower belt idler system Is designed to provide
constant tension on the belt.
Anti-Scalp Rollers
Secure rollers in top position for average lawn mowing.
Use lowest roller position when mowing in higher
cutting height or rough terrain to guard against most
scalping. Use top roller position when cutting at lowest
cutting height.
For a smooth appearance, cut lawn using frame
suspended models with anti-scalp rollers. Keep anti­
scalp roller adjusted to the minimum 1/2” above flat,
hard, smooth surface.
NOTE: Rollers are intended for anti-scalping, not for
controlling cutting height.
T ransport
Equipment should be shut off when transporting. To
move unit without the engine running, open the Dump
Valves (refer to Controls and Features). Close the
Dump Valves before operating.
IMPORTANT: NEVER push or pull (tow) the unit with
another vehicle. Use a truck or trailer when transporting
or transmission damage can occur.
C leaning and S torage
IMPORTANT: NEVER spray unit with water or store
unit outdoors to aid in prevention of rust or corrosion.
Water can seep into sealed bearings, which are sealed
against dirt and debris only, causing reduced
component life.
Keep all nuts, bolts and screws tight and be sure
equipment is in safe working condition. Check all
hardware at regular intervals.
Never store equipment with fuel in tank inside a
building where fumes may reach an open flame or
spark. Allow engine to cool before storing in any
enclosure.
Ariens» EZRider™ Orig. 1/98
21