Ariens 009-1648 - Manual (Page 16)

S tarting and S hut -O ff
See Figure 3 for Controls and Features Locations.
Starting
1. The operator must be seated.
2. Travel-Steering Control levers must be in the
“NEUTRAL LOCK” position (Figure 4).
3. The PTO Switch must be in the “OFF" position.
4. If the engine is cold, apply choke. See Engine
Manual for detailed instructions.
5. Set Throttle to proper starting position (see Engine
Manual).
6. Turn the ignition switch key clockwise to the
“START” position. Release the key when the
engine starts.
7. As soon as the engine starts, adjust choke as
needed. Wait until the engine is running smoothly
before operating the unit.
Shut-Off
1. With both Travel-Steering Control Levers pulled
back to centered (neutral) position, bring unit to a
complete stop on level ground.
2. Put PTO in the “OFF” position.
3. Move the Throttle Lever to “SLOW”.
4. Turn the Ignition Key to “OFF”.
5. Engage the Parking Brake.
O peration
See Figure 3 for Controls and Features Locations.
NOTE: This unit is equipped with an internal
combustion engine. DO NOT use equipment on or near
any unimproved, forest-covered or brush-covered land
unless exhaust system is equipped with a spark
arrestor meeting applicable local, state or federal laws.
A spark arrestor, if it is used, must be maintained in
effective working order by operator.
Speed
DO NOT operate and too fast a rate.
Sudden forward or backward movement in Travel-
Steering Control Lever(s) and fast speeds can
cause injury or death.
Move one or both Travel-Steering Control Lever(s)
forward and backward SLOWLY until you learn how to
operate the unit properly. The further you move the
levers, the faster the unit will travel.
NOTE: This unit is designed to be highly
maneuverable and responds quickly to movement of
the Travel-Steering Control Levers. Practice operation
of the controls in a flat open area until you are
comfortable with their operation. ALWAYS start and
backup slowly and make turns with caution.
M owing
To mow with the unit:
1. Adjust deck to desired height.
2. Move Throttle Lever to about half speed.
3. Pull the PTO Switch to the “ON” position to engage
the mower.
4. Move the Throttle Lever fon/vard to full engine
speed.
5. Move Travel-Steering Control Levers forward to
mow.
IMPORTANT: NEVER engage the PTO if the mower is
plugged with grass or other material. This may cause
damage to the PTO Belt.
12 Ariens® EZRider™ Orig. 1/98