Power take off (pto) switch, Attachment lift lever, Safety interiock system – Ariens 009-1648 User Manual
Page 15: Transmission dump vaives, Pre-start, Check tires, Check engine oil, Check seat adjustment, Test operation of all controls, Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Neutral Lock Position
Figure 4
Power Take Off (PTO) Switch
The Power Take Off Switch is used to engage and
disengage the attachment.
--------- When the PTO Switch is pulled out, it is in
the “ON” position and the attachment is
^ engaged.
When the PTO Switch is pushed in, it is in
^ the “OFF” position and the attachment is
disengaged.
Attachment Lift Lever
To raise the attachment, move the lever to
iWl'Ih the right to unlock It and pull up on lever.
I|||X To lower the attachment, move the lever to
the right to unlock It and push lever down.
Maximum cutting height is 5"; lowest cutting height is
1.38". Intermediate positions allow selection of cutting
heights between these values.
Safety interiock System
The engine must shut off if the operator leaves the seat
while the Travel-Speed Control Levers are In any
position other than the “NEUTRAL LOCK” position and
the PTO Switch is in the “ON” position.
Transmission Dump Vaives
Closing the Dump Valves allows the unit to by pushed
by hand. Dump Valves must be open to drive unit.
IMPORTANT: NEVER push or pull (tow) the unit with
another vehicle. Use a truck or trailer when transporting
or transmission damage can occur.
To Open the Dump Valves: Lift up on the Dump Valve
Rod and pull rearward until the expanded section of the
rod comes through the hole in the trailer hitch. Push the
rod back down to lock it into position (Figure 5).
To Close the Dump Valves: Lift up on the Dump Valve
Rod and push it back fon/vard.
1. Dump Valve Rod
2. Trailer Hitch
Figure 5
P
re
-S
tart
Check Tires
Before each use, make a visual check of tires.
Check Engine Oil
Check that the engine oil is at proper level using
dipstick. Fill or change per instructions in General
Maintenance.
Check Seat Adjustment
Be sure all controls can be reached safely from
operator’s position. If seat needs adjustment, refer to
Adjustments.
Test Operation of All Controls
A
CAUTION
Check function of all controls before starting engine.
All safety devices and guards must be in position
and operating properly or injury may result.
Ariens* EZRider'“ Orig. 1/98
11