MTD 214-412-000 - Manual (Page 6)

Assemble the side shields to the tine shield as
-shown in figure 7, using belleville washers (X)
(cupped side against the side shields) and hex
nuts (Y). Side shields will be adjusted up or down
as the depth bar is adjusted, as described in the
Operation section.
Assemble
in this
order
HANDLE ASSEMBLY
1. Place the handle assembly in position on the
tiller so that the holes in handle line up with
holes in mounting bracket.
2. Place flat washer (G) and belleville washer (F)
over shoulder on shoulder bolt (E). Place
shoulder bolt through handle mounting holes.
Secure with hex top lock nut (H) from the in-
----- side of handie. See figure 8.
FIGURE 8.
Hex Bolt (M)
Ra. \
Washer (W) V'
%
Handle , ,
Adjustment (N) Handle
Rod Adjustment
Lever
3. To assemble the handle adjustment lever (L),
hook handle adjustment rod (already on han­
dle) into lever. Hook to the outside.
Place a flat washer (W) on either side of the
handle inside of the handle adjustment lever.
Secure with hex bolt (M) and lock nut (N). See
figure 9. Do not over tighten. Handle adjust­
ment lever must pivot freely.
4.
FIGURE 9.