MTD 214-412-000 - Manual (Page 5)

Depth Bar
Assembly
Raise the tine shield hinge flap assembly. In­
sert the depth bar assembly up through the
-tine shield assembly as shown in figure 4.
FIGURE 4.
Depth Bar
Assembly
5. Place hex bolt (P) through depth bar assembly
and through notches in depth bar adjustment
plate. Head of hex bolt must be to right side of
the tiller. Place spacer (Q) on hex bolt. See
— figure 5.
FIGURE 5.
Depth Bar
Handle
ssembi
6
.
Place hole in depth bar handle assembly over
the spacer and hex bolt. Secure with flat
washer (R) and hex nut (S), tightening secure­
ly, then backing off one turn. Handle must be
able to pivot freely. See figure 6.
Place end of spring onto hex bolt. Thread hex
lock nut (T) on the bolt until the two nuts are
approximately 1/8" apart. See figure 6.
FIGURE 6.