MTD 24642S - Manual (Page 9)

NOTE
DO NOT operate log splitter without
proper amount of oil in reservoir tank
(beam).
2. Fill sump with oil as instructed in the separate
engine manual packed with your unit.
3. Fill fuel tank, using clean, fresh, regular grade
automotive gasoline. Fill tank completely.
NOTE
Refer to engine manual packed with
log splitter for complete instructions
for the care and maintenance of en­
gine.
READ DIRECTIONS CARE­
FULLY.
TO START ENGINE
1. Place throttle control lever in FAST or CHOKE
position. See figure 12.
2. Place choke control in CHOKE position (if unit
is so equipped).
NOTE
A warm engine may not require
choking.
FIGURE 12A - 5 H.P. Tecumseh engine shown
3. Grasp starter handle, place one foot on wheel and
pull starter handle with a quick, full arm stroke.
Return rope slowly to the engine.
4. After engine starts, move choke control gradually
to OFF position (if unit is so equipped). Move
throttle control to desired engine speed.
TO STOP ENGINE
1. Move throttle control lever to STOP position.
2. Disconnect spark plug wire from spark plug to
prevent accidental starting while equipment is
unattended.
USING YOUR LOG SPLITTER
áki
WARNING t
This unit should not be towed on any
street, highway or public road. Any
licensing needed to comply with the
existing federal, local or state vehicle
requirements is the sole responsibility
of the purchaser. Make certain the
stand is folded up against the beam
when transporting.
Your log splitter is designed for safe, efficient
operation. BE CAREFUL TO KEEP HANDS AND
FEET AWAY FROM MOVING PARTS.
Engagement handle has three positions: (See figure 13)
Forward - ram moves toward wedge.
Neutral - ram stops in place.
Reverse - ram returns.
ENGAGEMENT HANDLE
IN NEUTRAL POSITION. ENGAGEMENT HANDLE
HELD IN FORWARD
POSITION.
-r'-X'i
ENGAGEMENT HANDLE
LOCKED IN REVERSE
POSITION.
FIGURE 13
Maximum length that can be split is 26".