MTD 24642S - Manual (Page 5)

TOOLS REQUIRED:
(1) Raw Hide or Plastic Hammer
(1)
1-1/8" Wrench or Adjustable Wrench
J J ) 3/4" Wrench
THER MATERIALS WEEDED:
One gallon of regular grade gasoline (for engine)
1-1/2 pints of SAE 30 or 10W-30 oil (for engine)
Approximately 2-1/2 gallons of Dexron II auto­
matic transmission fluid (may be obtained at your
local service station or auto parts store.)
Funnel
[3F1
0
t
2
|<0))))))))))))))^MPM
Y
FIGURE 1
ASSEMBLY INSTRUCTIONS
CONTENTS OF HARDWARE PACK (See Figure 1):
A (2) Spacers 1-1/2" Long
B (2) Tapered Roller Bearings
C (2) Castle Nuts 3/4-16 Thread
D (2) Cotter Pins
E (2) Hub Caps
F (5) Hex Bolts 3/8-24 X 1" Long
G (9) Lock Washers 3/8" I.D.
H (10) Hex Nuts 3/8-24 Thread
I (1) Hex Bolt 1/4-20 X 1-3/4" Long
J (1) Hex Lock Nut 1/4-20 Thread
K (1) Hex Lock Nut 5/16-18 Thread
L
(1) Shoulder Bolt
M (1) Rubber Washer
N (1) Hex Nut 3/8-16 Thread
0 (3) Hex Bolts 3/8-16 x 3/4" Long
P (2) Shoulder Bolts
Q (2) Lock Washers 5/16" I.D.
R (2) Hex Nuts 5/16-18 Thread
S (1) Automotive Grease
T (1) Hex Bolt 1/4-28 X 1" Long
U (1) Hex Bolt 3/8-24 x 1-3/4" Long
V (1) Hex Nut 1/4-28 Thread
W (1) Hex Lock Nut 1/4-28 Thread
X (3) Flat Washers (Special)
Y (1) Spring
Z (2) Pivot Brackets
LOOSE PARTS IN CARTON:
(1) Axle Assembly
(2) Wheels
(2) Tow Hitch Brackets
(1) Tow Hitch Assembly
(1) Pivot Stand
(1) Hitch Chain
(1) Engagement Rod Assembly
(1) Engagement Handle
Remove log splitter and loose parts from carton. Make
certain all parts and literature have been removed
from the carton before the carton is discarded.
INSTALLATION OF WHEELS
1. Place the axle assembly in position inside the
the engine frame assembly as shown in figure 2.
Secure with hex bolts (F), lock washers (G) and
hex nuts (H).
WASHER (G)
FIGURE 2