3. how to change threads – SINGER WSL7234 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2-3. How to Change Threads
The machine is supplied with thread but the fol
lowing is an easy way to change them:
(
1
) Cut the thread in use near the cone spool
(behind the telescopic thread stand). Place the
new thread on the spindle and tie it to the end
of the original thread.
V
Tie threads
Cut thread
J
(2) Lower the presser foot lifter to lift up the press
er foot.
(3) Set tensions to 0 so that the thread knot can
pass through smoothly, draw out the looper thread
until the thread knot comes to about 10 cm past
the presser foot.
(4) When changing the needle thread, cut off the
thread knot before it reaches the eye of the nee
dle to avoid bending the needle as the knot is
pulled and caught in the needle’s eye.
To make the above threading easier, use tweezers.