Removing covers, bobbin case, and bulb, Removing and replacing top cover, Removing and replacing bottom cover – SINGER 719 User Manual
Page 29: Removing and replacing carrying case base
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
removing covers,
bobbin case, and bulb
CAUTiONi
Before
removing
covers,
bobbin
case,
and
light
bulb,
disconnect
pov/erdine
plug from your electrical supply,
REMOVING AND REPLACING
TOP COVER
Move take-up lever to a low point and lower
the pressor foot,
1.
Loosen
and
remove
screw
A,
lift
up
right
end
of
top
cover,
and
slide
cover
toward
left and off machine,
2.
Replace
cover
by
positioning
it
on
top
of
arm with a
slight
overhang on left side,
3.
Engage
bobbin
winder
latch
and
slide
cover
to the right
as far as It will go.
Replace and
securely tighten screw A.
4. Release bobbin winder latch.
REMOVING AND REPLACING
BOTTOM COVER
If your machine Is a portable, first remove the
carrying case base as instructed below,
1.
Tilt
machine
back
and
remove
screws
from
center
of
bottom
cover.
Pull
cover
straight
up (parallel to machine bed) to remove.
2.
Replace
bottom
cover
by
positioning
slots
in
cover
over
bed
cushion
pins
at
the
four
corners
of
the
machine
bed.
Push
down
on
cover
to
snap
it
into
place.
Replace
and
tighten screw in center of cover.
REMOVING AND REPLACING
CARRYING CASE BASE
1.
Disconnect
machine
plug
from
electrical
receptacle at right end of machine,
2.
Turn
machine
over
on
its
back
and
remove
screws
and
washers
from
each
end
of
base.
Set
machine
and
base
upright
and
lift
ma
chine up and out of base.
3.
Replace
machine
in
base
after
bottom
cover
has
been
attached.
Turn
machine
and
base
over
together
to
replace
washers
and
screws on underside. Tighten screws.
Removing and Replacing Top Cover
t
Removing and Replacing Bottom Cover
Retaining Screv/s and Washers
0
0
Carrying Case Base
27