SINGER W150 FL - Manual (Page 8)

1. TO SET THE NEEDLE
NEEDLE
FLAT
■SURFACE
(1) Turn fhe Balance wheel toward you,
raising needle bar to its highest point,
and loosen the needle clamp screw.
(2) Hold the needle in the left hand with
the point down, and insert the needle
clamp as far as it will go, with its flat
surface to the right; then retighten the
clamp screw (Fig I)
2. TO WIND THE BOBBIN
0) Disconnect the balance wheel from the stitching mechanism by holding the balance
wheel with your left bond- and turning fhe sfopmotion knob COUNTERCLOCKWISE
with your right hand. - (Fig. 2)
(2) Raise the folded spool pin (6) and place a
spool of thread on it. (Fig. 3)
Fig 2
Fig. 3
SPECIAL FEATURES
TO SET THE NEEDLE • TO WIND THE BOBBIN
TO THREAD THE BOBBIN CASE
TO REPLACE AND REMOVE THE BOBBIN CASE TO CLEAN SNAP-OPEN RACE
TO THREAD THE MACHINE & NEEDLE TO PREPARE FOR SEWING • TO COMMENCE SEWING
TO REMOVE THE WORK • TO REGULATE THE THREAD TENSION • TO REGULATE THE STITCH LENGTH
TO REGULATE THE PRESSURE OF THE PRESSER FOOT TO USE THE DROP FEED DIAL
BUILT-IN LIGHT TO OIL SEWING MACHINE
SOME USEFUL SEWING HINTS CAUSES OF COMMON DlFFrCULTlES
'NEEDLEliND^HREAD^SiZES ^ ^ ^