Zh reading the bobbin case, I*»*' f f - i – SINGER W1305 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Zh reading the Bobbin Case
i*»*'
f f - i.
Hold the bobbin case between the thumb and
forefinger of your left hand with the slot in the
edge facing up.
Hold the wound bobbin between the thumb and
two fingers of your right hand with the thread on
top leading away from you (see picture).
Insert the bobbin into the case, pull the thread
into the slot; then down under the spring, until it
enters the delivery eye.
ii?:-
(Be sure the needle is at its highest point.)
Hold
the
bobbin
cose
with
your
left
hand
by
the
hinged-latch,
with
the
metal
finger
of the case pointing up and in line with the
notch at the top of the shuttle raceway.
Release
the
hinged-latch,
and
fitting
the
centre
of
the
bobbin
over
the
center-pin
protruding from the racev./ay, press the bobbin
gently into position, being sure that the metal
finger fits into the notch of the raceway.
The 5 or 6 inches of thread hanging freely
from the case wii i be brought up later through
the hole in the centre of the ’needle plate.
Close the slide plate.