To set the j^ecdk, Wtauec – SINGER W1305 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
to Set the J^ecdk
m
FLAT
SIDE
Raise needle to its highest point by turn
ing the balance wheel toward you by hand.
Loosen the needle-clamp screw on the
right hand side of the needle bar. Remove
the old needle, and slide new needle up
(FLAT
SIDE
TOWARD
BALANCE
WHEEL) until it hits the stop. Then
tighten the needle-clamp screw securely.
For best results, change needles frequently.
WtaUec
.y-7*
m
WHEN
SEWING,
WINDING
BOBBINS,
or
CHANGING
NEEDLES
ALWAYS
TURN
THE BALANCE WHEEL TOWARDS YOU
The balance wheel is provided with
a stop-motion device which allows the
balance wheel to run freely so that
bobbins may be wound without operat
ing the needle.
To loosen the wheel, hold it tightly
with the left hand, and with the right
hand, turn the stop-motion knob toward
you. See arrow.
To tighten the balance wheel, turn
stop-motion knob away from you.