SINGER W312 Old - Manual (Page 43)

THE SET OF HEMMERS
9fof8 attaching any of the hemmers, be sure bobbin thread is pulled up.
hen, with hemmer in place, hold top thread loosely
and turn
;andwheel one- full turn . toward you, making a loop under
emmer. Grasp bobbin thread with both hands and slip horizontally under hemmer
oward back. Bobbin thread will catch loop and carry upper thread to back of
lemmer.
-old material to suit for two inches along edge, hold at each end of fold. Slip fold
nto guide and up over spoon. Fold hem in material back of hemmer. Draw forward
o end of hem and fasten with point of needle. Pull on threads gently as you start
titching.
ou can make a hem 1/4", 3/8", 5/8" or 7/8" in width, depending upon which
;';rnmer you use. A few uses are shown below.