Problem and remedies – SINGER W312 Old User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

PROBLEM AND REMEDIES
RGmèdiés
If fviachine
iiiSiiÎpping^
Stitch'js
; ir régit lat;:
Stitches-'
Uneven'
Stitches
Upper
Thread
Breaking .
Material
-
Puckering::
:i Thread -od itnt;.iri;-Faceri. :
::iWèèdrë;dlac^
■■ rectiy in ciamp; ■■
«TooTirte-a needle Tort.:
thread.bemg lisôcl. /
Too stretchy fabric...
.Upper-thtsad-tension-t::
. top- loose;'
' Improper threading. ^..
Bobbin not wound
evenly.
Pulling or holding
- material. -
;-Notî,srî6ugh:tension
-
.-on upper thread.
Poor quality thread. -
Needle too fine for
i thread: being.used..
■: Improperly threaded.:
Too much tension.
Starting with take-up
in incorrect position.
Improper setting of ■ ■
. needle,
: Bent oreye of needle
■: too sharp; :.:
Ben cor blunt needle.-,
: Tensions too tight.
Dull needle;
Stitch length too long,.
:|çiean.i::'àn(i;; oîl::i.maebinéith&:s
;ï:area^:(Sëè:page;-36ïh:;^^^^^^^^^^^
TBep|ac0';td névv peed
iïÈlace'néedtecorrectïÿi.j (Séé pàgeCTO
t
icr-Wtr.
each other, (See page 9.) --.
Place a paper- beneath fabric, or
Batf Point needle
Tighten upper tension. - -.
See thre^fing instruction, page 13. '
Adjust bobbin winder. (See page 38.)
■:Avoid:pul(ing or holding:material, just:- -i
guide it. '
■ Increase tension.
Try different thread,
:- See; needle and thread chart, page 9. ;
■'
::: Refer to threading instructiorssi see . ' ..; -
: page 13, and rethread machine, .
•
.:Loosen upper thread tension.
{See page 18-1
:- Always start sewing with take-up; lever:
. in highest position,
sf Refer to needle setting instruction, see;
page 10. ;
. Try a new needle.
i Discard all blunt or bent needles and ’
: replace with new.
See. tension adjustment, page 18.
■ Change needle,
: Reduce stitch length.
Machine noisy
Si material wilt ; -
not feud in
stretch stitching.-
improper
feeding; ;■
Stitch-length control.:
is set at other than
Number 4.i ; ;
Lincin feed dog;
Set stitch length control at Number 4.
: Remove needle plate and clean lint .from;
feed dog.
,
39