SINGER W165 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Move zigzag stitch width lever- "2" to its extreme left hand position and set the stitch

length where you prefer it, but remember that most embroidery designs require a stitch length
of

or less for best appearance.

To remove cam, open door covering cam chamber, move lever *'2" to the right as far as

it will go and lift cam off the spindle.'

BLIND HEMS

Use blind stitch cam.
Use standard zigzag prssser foot and needle plate.
Set zigzag stitch width control knob at 0.
Set stitch length control knob between 2 and 3.

Prepare the garment in the same manner as for hand hemming.
Step 1. (Fig. 26) If hem with folded edge is used make first fold 3/8" deep.
Step 2. Turn hem the depth desired and baste 1/4" from upper edge. Press into place.

Step 3. Fold hem back toward right side of garment leaving 1/4" extended.
Step 4. Place material under presser foot and sew blind hem automatically.

Blind hem completed.

■lij