SINGER 99-13 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Have tlic lake-iip lever at, its liigliest point, llieii
wilh
the
left
haml
hold
the
end
of
the
needle
tliread, leaving it slack from the hand to the neeille.
1(5
To Prepare for Sewing
Fio. U. D
uawinu
U
p
tub
B
ouuin
T
ukeau
'rum the halanee wheel over towanl you until the
needle moves down and up again to its highest point,
thus catching the bohinn thread; draw up the needle
thrtaul aui.1 the bobbin threatl will come up with it
through the hole in the throat plate (.see I'ig. 1-1).
Lay both threads back under the presser fool.
To Commence Sewing
Place the material beneath the presser foot, lower
the presser foot and commence to sew', prejising the
knee lever to the right to start the machine.
Let the thread take-up lever
rest at its highest
point, rai.se the pie.s.ser foot and draw the fabric back
ami to the left, p,a.ss the threads over the Ihreail
cutter (tj, Pig. 14, page 10) and pull dow'ii lightly to
sever
them.
Leave
the
ends
of
the
Ihreail
under
the i)ie.s.si'r fool.
Tensions
Por
ordinary
stitching,
the
needle
and
bol.biu
threads should be locked in the. centre of the thick-
ness of the nmicriill, thus:
17
To Remove the Work
Fuj. 1;">. 1*KKKKL'T SiTivH
if the tension on l iio neetlle tln-eiul is too tight, or
if that on the bolihin limiacl is too loose, the neetlle
thieail will lie sliaight ahmg the upper surface of
the material, thus:
F
ig
. 10. 'I'lGiiT NcifOLh:
T
ension
If the Icitsion on the l>ol>I)iu thi'catl is too tight, or
if that on Iho needle thread is too loosci, the bobbin
thread will lie straight along the under side of the
inatorial, thus:
Fiu. 17. Luosu NKEULk: T
uue
.\
d
T
ension