Threading bobbin case – SINGER W910 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

THREADING BOBBIN CASE
. Hold bobbin case be
tween thumb and fore
finger of left hand, so
that the slot in the edge
of the bobbin case is on
top.
Take
the
bobbin
between thumb and fore
finger of right hand so
that the thread on top
leads from left to right
Insert bobbin into bob
bin case, pull the thread
into
the
slot
of
the
bobbin case and draw it
under tension spring and
into
the
fork-shaped
opening of the spring.
I
I
PLACING BOBBIN CASE IN SHUTTLE
Raise needle bar to its highest position, and slide plate
forward. Hold the bobbin case latch (D) between the
thumb and forefinger of the left hand, with at least three
inches of thread running from the top of the bobbin
case. Insert and center the bobbin case on the stud of
the shuttle body (C). Be sure the bobbin case finger (E)
is opposite the shuttle race notch (A). Press the bobbin
case (B) into the shuttle as far as possible until the latch
catches on the center post of the shuttle. Then release
the bobbin case latch (D). Press the bobbin case again
after the latch has been released to make sure the bobbin
case is locked securely in place. Close the slide plate.