Iyiy!tl* *stitcli zig-zag bar tacks – SINGER 1280 User Manual

Page 59

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

iyiy!tl* *Stitcli Zig-Zag Bar Tacks

With the multi-stitch zig-zag you can make strong bar
tacks. Multi-stitch zig-zag bar tacks are effective for
tacking belt

loops

on heavy fabrics such as denim, 8e

sure to check the Fabric, Thread and Needle Table on
page 16 for correct

thread

and needle selection with

your choice of fabric.

Paitetn

Group:

(Blue)

♦ Needle Position: JL iXj ^

♦ Stitch Width:;

I I I f j ]

♦ Stitch Length:

0 to 1

♦ Snap-in feed cover.

General

pi^rpose

foot or special purpose foot,

We recommend making a test sample first using
scraps of the material you will be sewing the bar tacks

on. duplicating all thicknesses.

1. Mark position for the finished end of belt loop on

the fabric.

♦ Place belt loop, wrong side up, straight stitch with

cut end 3 mm (1 /8 inch) fromi edge of garment: do
not stitch beyond edges of the belt loop. Trim the
end close to the stitching and press.

2 Fold belt loop back on the stitching line and press.

• Set your machine according to the code above,

* Stitch 3 mm (1/8 inch) from the fold using the

multi-stitch zig-zag.

Fold over loose end and bar tack.