SINGER 1280 - Manual (Page 21)

The Bobbin Thread
Winding the Bobbin
Preparation Steps
1. Raise the presser foot and turn hand wheei toward
you until needle is in highest position.
Z* Loosen hand wheel knob A by turning it toward you
with the right hand while holding hand wheel with
the left hand.
3. Place thread spool on spool pin with thread retain­
ing silt B to the right. (Break paper at the end of
spool if necessary,)
• Place spool holder C on spool pin and press firmly
against the thread spooi.
Winding Steps
• Snap thread into thread guide post D and open top
cover.
• Lead thread around bobbin v^inder tension disc E,
as illustrated, and through small hole in bobbin from
inside out.
• Place bobbin on spindle and move bobbin wmder
F to right.
• Hold thread end and start the machine. Cut off
thread end after a few coils have been wound.
• When reouired amount of thread has been wound
(winding will stop when bobbin is full) stop machine
and cut connecting thread.
• Move bobbin winder to the left and remove bobbin,
• Hold hand wheel and tighten hand wheel knob.