SINGER W1465 User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
34
BINDER
Tills attachment folds bias binding, applies it to the
edge of material in one operation. Slots on scroll of
the binder are for corresponding widths of commercial
folded bias binding.
The open mouth of binder scroll is used for un
folded bias strips cut 15/16 inch wide.
FOLDED BINDING (Fig. 53)
Cut a point on folded binding, insert in appropriate
slot. Draw through slot and under binder with strong
pin. Test stitching to be sure it is on the edge. Adjust
by sliding binder to right or left.
TWO-TONE BINDING (Fig. 53)
Two bindings can be sewn on fabric edge also in
one
operation.
When
two
are
used,
always
skip
one
size between widths, inserting each in correct size slot.
HAND-CUT BIAS BINDING (Fig. 54)
Cut
15/16
inch
bias
binding
fold
in
half
for
a
couple
of
inches.
Cut
binding
diagonally
toward
end,
almost to fold. Slip fold into center of binder. Draw
back
until
cut
opens
and
binding
encircles
open
end
of scroll. Test stitching to be sure it is on the edge
adjust if necessary.
Fig. 53
c
c
Fig. 54