SINGER W1465 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
UPPER THREADING
(Fig. 10)
1. Turn the hand wheel toward you to raise the take-
up lever and needle to their highest position.
2. Place spool of thread on the spool pin nearer the
needle.
3. Lead thread through rear and front arm thread
guides A.
4. Down and between tension discs B from right to left
5. up and around into the notch on check spring C
over tension discs
6. Down under thread guide bar and into guide D
7. up into take-up lever from right to left E
8. down through guide D in thread bar again
9. into thread guide F
10.
through needle clamp guide G and into needle from
left
to right
pulling three to four inches of thread
through needle.
-'i'- ^
Kil:; i
: e! . <*1 u'l
Fig. 11
Hold
the
end
of
upper
thread
loosely
and
turn
hand
wheel
toward
you
until
the
needle
goes
all
the
way
down
and
comes
back
up.
A
loop
will
be
formed
over
the
upper
thread
which
then
can
be
pulled
out
straight
(Fig.
11).
Place
both
thread
ends
under
the
slot
of
the presser foot and toward the back of the machine, leaving both threads three or four inches
long.