SINGER W1717 - Manual (Page 6)

Connecting foot controller
and power cord
Oonnect foot controller and
power cord '
1,1 2 a
Before plugging in your machine,
sure that voltage is same as
that of your machine, (written on
a:plate at back of machine)
a Switch on put power on the
machine and turn on the sewing
lifht.
bj Push button to turn sewing
li|ht on and off.
Always switch off or unplug
machine when not in use.
* Specifications vary from country
tp country.
The more you press foot controller,
the faster the machine runs.
Changing Needle
Set needle in the highest
position by turning handwheel
towards you.
Loosen needle clamp screw and
remove needle.
With flat face away from you,
insert a new needle into groove
of needle bar.
Push needle until it reaches
stopper (a) and tighten needle
clamp screw firmly.
Always use a straight needle with
a sharp point.
Using defective or worn needles
not only causes stitch skipping,
breakage of needles or snapping
of thread: it also can damage
hook and needle plate.