SINGER W1717 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
^.MAKING BUTTONHOLES
$et machine as shown.
Determine Length
Nleasure diameter and thickness
of button and add 0.3cm (1/8'')
f(jir bar tacks.
Mark buttonhole size on material.
Determine Width
Dptermine width according to
diameter of button, its thickness,
arjid kind of material.
Attach buttonhole foot,
mpletely push back sliding part
of buttonhole foot,
ice material under foot so that
arking of buttonhole passes
ough center of foot and arrow
of foot indicates beginning line
marking.
Co
PIB
m
thr
'.b.
of
Bar tacking: Set pattern selection
dial to 1
(,B^) and sew 5^6
stitches.
Left side: Change pattern to 2
(al]). Sew left side from front to
back until it reaches end line.
Remember the point where arrow
shows so that it is not necessary
to mark end lines for all
buttonholes.
Bar tacking: Change pattern to 3
(
) and sew 5-6 stitches.
Right side: Change pattern to 4
([(■*) and sew right side until it
catches first bar tack.
Quick
finish;
To
prevent
unstitching, set zigzag width at
0 and proceed for a few stitches.