SINGER W211 - Manual (Page 21)

BUTTONHOLE PREPARATION
Step 5,
Step!. Step 2. Step 3. Step 4.
Seam Ripper
0 ea 1 .
Needle PosIMon Selector ano
Zigzag Width Control Dial
Stitch Length
Control Dial
PROCEDURE:
• Attach buttonhole foot to machine.
• Before starting to sew, always pull the buttonhole box toward you
until it is fully extended.
• Mark position of buttonhole on fabric to assure proper alignment.
Step 1 ; Set ihe stitch length control dial between 0 and 1, and the
needle position dial at ” Press drop feed button,
take few stitches to bartack the end of marked buttonhole
with the zigzag width control dial "5".
Step 2; Press "MU drop feed button, set stitch width dial between
1 and 2, then sew down the left edge of marked buttonhole.
Step 3: With needle in the fabric on the left side, and repeat as in Step 1
at the left edge position of marked buttonhole.
Step 4: Press "MÈL drop feed button, and set the needle position dial at
"■4 " and between 1 and 2 of zigzag stitch width. Press reverse
button of stitch length for reverse stitching, then sew up the
right edge of marked buttonhole.
Step 5; With down position feed dog height, cut center open space with
seam ripper of buttonhole carefully not to cut into the stitches
19