Removing the material, Crossing heavy seams – SINGER W211 User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CHANGING
DIRECTION OF SEWING:

• Before changing direction,

stop the machine at the desired
point making sure that the
needle is down through the

fabric.

• Raise ttre presser foot, turn

the fabric to the desired posi

tion, lower the presser foot
and continue sewing.

Note: When sewing with a twin
needle, it is necessary to raise
the needles above the fabric
before turning. Be cautious to
realign the fabric to the position

where the last stitch ends.

REMOVING
THE MATERIAL:

After stopping the machine,

turn the hand wheel toward you

until the take up lever is at its

highest position.

Raise the presser foot, then

draw the fabric gently to the

left rear of the machine, making

sure that the threads are under

the foot. This avoids bending

the needle.

With two hands, lift the two

threads up and into the thread

cutter on the presser bar and

pull down firmly to cut the

threads.

CROSSING

HEAVY SEAMS:

When crossing heavy seams,

angle the fabric down into the

foot so that the foot can draw

the heavy area into the feeding

mechanism and pass over the
bulk easily.