SINGER 7025 - Manual (Page 52)

Attaching a button
Flat buttons can be sewn on quickly and easily
using the plain zig-zag stitch. A special button
sewing foot (H), may be purchased at your
sewing center.
Recommended settings
Stitch Selection: Zig-Zag Stitch
Needle Position:
Stitch Width: To suit Button
Button Sewing (H)
' (Additional Accessory)
Needle Plate: General Purpose (A)
Attach Feed Cover (F)
Before you can attach a button, the bobbin
thread must be brought up through the hole
in the feed cover.
1 Set stitch width at ( ; ), and needle
position selector at ( j j ). Position button
under foot and lower the needle into the
center of the left hole. Lower the foot. Turn
hand wheel toward you until needle rises
out of button and is above the foot.
a
2. Move stitch width selector until needle is
over the other hole in the button. Then,
when you begin to stitch, the needle should
enter into the right hole of the button. Take
six or more zig-zag stitches to attach button
and finish with the needle on the left side.
3. To fasten stitching, adjust width to ( ; )
and take three or four stitches. Remove
work, draw threads to underside, fasten,
and trim. a
50