SINGER W2137 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
E.
Drop feed, lock stitch width at 4, take 3 or 4 stitches, leave needle in fabric left
of stitches. Pivot fabric on needle to make next daisy petal. Continue until flower
design is complete. Lock threads by setting stitch width at 0 and taking 3 or 4
stitches in center of design.
Twin Needle Work See Figs. 24 and 25
Variations of the designs shown in Fig. 24 (with the exception of the daisy; may be
done with twin needles
when the right stitch lock is set on No.
IV2
width.
Always turn the wheel by hand to be sure needles do not strike either side of the
needle plate hole.
A.
Set locks at 0 and 1 V 2 - Move lever at even pace from 0 to IV2, and back. Keep
repeating in rhythm.
B.
Set stitch length at 2, the stitch width at 1. Do a few zigzag stitches, drop feed
for
3
or
4
stitches,
then
raise
feed
quickly.
By
operating
the
feed
knob
rhyih-
mically, it is not necessary to count stitches to obtain uniformity of pattern.
C.
Set width locks at M and IV2. Sew a few stitches at IV2, then quickly move
lever
to
V2.
Repeat
the
back
and
forth
movement
while
running
machine
rather
slowly.
„ 21 --