SINGER W2137 - Manual (Page 19)

to begin sewing. By having the needle at its highest
point it is not necessary to touch the hand wheel to start
the machine. You merely press the control. The speed of
the machine is regulated by increasing or decreasing the
amount of pressure exerted on the control.
REMOVING THE WORK
Be sure to stop the machine when the thread take-up
lever and needle bar are located at the highest position.
Now raise the presser foot and draw the fabric back and
to the left, Figs. 20 and 21, and pass the threads over
the thread cutter. Pull down slightly, holding thread in
both hands, so as not to bend the needle. Leave the ends
of thread under the presser foot.
Fig. 21
17