Auto reverse (112r mkii only) : in one-time, Osc and 10 khz (122 mkiii only), Bias/level trimmers (122 mkiii only) : for – Tascam 122MKIII User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
15. MPX FILTER
: For making Dolby recording of FM
broadcasts. Without this filter, the pilot tone (19 Hz) and
subcarrier note (38 kHz) contained in FM programs may
"thwart" the DOLBY NR system.
16.
DOLBY NR
: Selects the Dolby B or C Noise
Reduction system or defeats them.
17.
INPUTS, L and R
: These 1/4" jacks accept
unbalanced line-level signals.
NOTE
Connecting signals to the front input jacks defeats the
rear input jacks. You cannot use both jacks at one
time.
18. PHONES
: The knob adjusts the listening level in the
headphones plugged into the adjacent jack.
19. REPEAT
: Initiates repeat play between Memo 1 and
Memo 2 (p.l2)
20. MEMO IN
; If pressed together with LOG 1 or 2,
stores the current tape point into memory.
cr
MEMO IN cannot operate during repeat play or when
the tape is fast-winding as a result of pressing either
LOG.
21. RTZ
: Fast-winds the tape at either direction, stopping
when the tape counter reads 00 00. Inertia may carry the
tape slightly past the 00 00 point.
!CF
DIRECTION cannot operate during :
O Repeat play
O
Search with LOG or CPS
o Fast cueing
o 4-second blank recording
O”
If pressed while in F.FWD or REW, switches the tape
side to play (or record) only when the tape reaches the
end or beginning or when stop is pressed.
24. Auto Reverse (112R MKII only)
: In one-time,
auto-reverse mode (
), both sides of the tape play or
record and stop. But, if play or record starts on the reverse
tape side, only that tape side plays or records and stops.
In continuous reverse mode (
ctld
), the entire tape plays
up to five times and stops, or both sides of the tape record
and stop.
25.
ADJUST (122 MKIII only) :
If pressed when
MONITOR is set to AUTO and the transport is in Record
mode, allows you to press the OSC and 10 kHz switches
and to "fine tune" the BIAS and LEVEL settings. For more
details, see page 15.
Pressing
26. OSC and 10 kHz (122 MKIII only)
OSC after ADJUST allows you to get 400 Hz or 10 kHz
oscillator signals for BIAS and LEVEL adjustments (you
get a 400 Hz signal unless you press the 10 kHz switch).
27. BIAS/LEVEL trimmers (122 MKIII only)
: For
precise calibration of the bias/record levels to the tape being
used.
22. LOC, 1 and 2
: Locate the tape to Memo 1 and
Memo 2 points, respectively.
23. DIRECTION (112R MKII only)
: Switches over
the tape side to play or record.