Tascam 122MKIII - Manual (Page 12)

Repeat Play
~o-
A repeat function continually plays a segment between two memory points.
1. Mark the desired start point with MEMO IN and LOC 1, and the end of the
segment you want to repeat with the MEMO IN and LOC 2.
2. Press REPEAT.
The tape will be located to the Memo 1 point and start playing, automatically.
When it plays up to the Memo 2 point, it will again rewind to the Memo 1
point to resume playback.
• To exit the repeat mode, press REPEAT again.
O’ REPEAT is locked out during Record or Record Pause (Ready).
■ 122 MKIII/112 MKII: The Memo 1 point does NOT have to be higher than the
Memo 2 point. The tape will play to the higher Memo point on the tape,
rewind to the lower Memo point.
■ 112R MKII : The tape always plays to the Memo 2 point and rewinds to the
Memo 1 point: Memo 2 should be higher than Memo 1.
■ If you press LOC 1/2 during repeat play, the tape will be located to the Memo
1/2 point and start playing or rewind to the lower Memo point.
■ If you press a transport control, the function pressed is activated and the repeat
play mode is temporarily disabled; and the repeat sequence will resume when
you
o Press LOC 1 or 2, or
o Press PLAY when you are somewhere inside the programed loop or at a
point lower than the start point of loop.
112R MKII : To create a repeat loop over both tape sides, use the
continuous reverse mode ( czs >):
A ; Start point (Memo 1)
A : End point (Memo 2)
—►: Play
Opposite Tape Side
- - ►: Skip
cj> : Fonward play direction
. Leader Leader X
) Tape 1 . 1 Tape
J
Tape Side Facing You
12