Tascam 122MKIII - Manual (Page 14)

t»
2. Specify how many selections from the current tape location is the desired
selection by pressing MEMO IN as many times as necessary. Each time you
press MEMO IN the number in the tape counter window will increment. You
can enter up to 15.
You can hold MEMO IN to scroll up the numbers.
3. Depending on whether your selection is ahead or behind the current tape
location, press F.FWD or REW.
4. Each time a blank space of about 4 seconds is encountered, the tape counter
display will decrement, and at the end of search operation, the tape will
automatically start playing.
■ Before pressing F.FWD or REW in step 3 if any of the following is pressed,
the function pressed is activated and the CPS mode is disabled ;
o Transport controls except F.FWD and REW
o RTZ
o LOC 1/2
o REPEAT
■ If you press F.FWD or REW after once search starts, the function pressed is
activated and the CPS mode is disabled.
■ In continuous reverse mode ( CZD ), you can skip to a selection on either tape
side.
In once-through reverse mode ( ), you can skip from the tape side facing
you to a selection on the reverse tape side, but you cannot skip from the reverse
tape side to a selection on the tape side facing you ; the tape will stop when
either end of the reverse tape side is reached.
High speed cueing functions (#4 and 5, page 6): Depending on some conditions such as type of
tape in use, environmental temperature and humidity, etc. reverse cueing may not possibly start, or may start
but not smoothly, if the current tape location is close to the beginning of the tape. Similarly, the forward cueing
may not possibly start as expected if attempted near the end of the tape.
14