Switch replacement, Depth adjusting ring adjustments or replacement, Maintenance – Sears 315.17473 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MAINTENANCE
SWITCH REPLACEMENT
See Figures 15 & 16.
1. UNPLUG YOUR ROUTER.
WARNING: FAILURE TO UNPLUG YOUR ROUTER
COULD RESULT IN ACCIDENTAL STARTING
CAUSING SERIOUS INJURY.
2. Remove screws (A) and handle cover (B). See Fig. 15.
3.
NOTE THE LOCATION OF MOLDED BEND RELIEF
(C) ON POWER HANDLE CORD AND ALL WIRING
IN HANDLE. ALSO NOTE HOW EACH LEAD IS
CONNECTED TO SWITCH. The side of the variable
speed control switch Is marked with Identification
numbers. Connections and wiring position must be
identical when Installing new switch. See Figure 16.
4.
Remove leads from switch (D) by inserting a 1/32 in.
diameter naii or pin into switch iead receptacie and
pulling on lead as shown in figure 16. Remove nail or
pin with a twisting, pulling motion.
5.
Make lead connections to the new switch. Push each
lead as far as possible into proper receptacle in switch.
Pull on leads to check lead connections with lead re
ceptacles.
6.
Locate switch in handle and place leads so they won't
be pinched or contact screws when handle cover is
replaced.
7. Make sure molded bend relief (C) is correctly positioned
in switch handle, then replace handle cover and screws.
8. Tighten all screws securely.
DEPTH ADJUSTING RING
ADJUSTMENTS OR REPLACEMENT
Tension on the depth adjusting ring has been factory set for
properly tightening depth of cut settings. However, ex
tended use may require that adjustments or replacement
be made to depth adjusting ring. See Figures 17-19.
1. UNPLUG YOUR ROUTER.
WARNING: FAILURE TO UNPLUG YOUR ROUTER
COULD RESULT IN ACCIDENTAL STARTING
CAUSING SERIOUS INJURY.
To make adjustments to depth adjusting ring:
2.
Tighten or loosen top screw in depth adjusting ring.
See Figure 17. Make adjustments with top screw only.
WARNING: THE DEPTH ADJUSTING RING SECURES
THE MOTOR HOUSING TO THE BASE, PREVENTING
THEM FROM SEPARATING DURING USE. IMPROPER
ADJUSTMENT OF SCREWS COULD CAUSE MOTOR
HOUSING TO SEPARATE FROM BASE RESULTING
IN POSSIBLE SERIOUS INJURY.
To replace depth adjusting ring:
3.
Remove depth stop rings. To remove: Depress lip on
depth stop ring and slide end of depth stop ring over lip.
See Figure 17.
4.
Remove screw from rear of depth adjusting ring. See
Figure 18.
DEPTH
STOP RING
Page 12