Maintenance, General, Proper care of cutters – Sears 315.17473 User Manual
Page 11: Light bulb replacement, Proper care of collet, Lubrication
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

MAINTENANCE
WARNING; WHEN SERVICING USE ONLY IDENTICAL CRA FTSMAN REPLACEMENT PARTS. USE OF
ANY OTHER PARTS MAY CREATE A HAZARD OR CAUSE PRODUCT DAMAGE.
GENERAL
Only the parts shown on parts list, page 15, are Intended to
be repaired or replaced by the customer. All other parts
represent an Important part of the double Insulation system
and should be serviced only by a qualified Sears service
technician.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
WARNING; DO NOT AT ANY TIME LET BRAKE
FLUIDS.
GASOLINE.
PETROLEUM-BASED
PRODUCTS, PENETRATING OILS. ETC. COME
IN CONTACT WITH PLASTIC PARTS. THEY
CONTAIN CHEMICALS THAT CAN DAMAGE,
WEAKEN, OR DESTROY PLASTIC.
PROPER CARE OF CUTTERS
Get faster more accurate cutting results by keeping cutters
clean and sharp. Remove all accumulated pitch and gum from
cutters after each use.
A cutter sharpening kit (Item No. 9-66501) is available from
Sears Retail Stores.
When sharpening cutters, sharpen only the inside of the
cutting edge. Never grind the outside diameter. Be sure when
sharpening the end of a cutter to grind the clearance angle the
same as originally ground.
LIGHT BULB REPLACEMENT
See Figure 14.
1. UNPLUG YOUR ROUTER.
WARNING:
FAILURE TO UNPLUG YOUR
ROUTER COULD RESULT IN ACCIDENTAL
STARTING CAUSING SERIOUS INJURY.
2
.
3.
4.
5.
6.
7.
8
.
Remove cutter from router.
Adjust router to maximum height.
Remove screws (A) and subbase (B). See Rgure 14.
Remove screw (C) and work light lens (D).
With bulb (E) pointing toward you, push bulb in and turn
to the left to remove from bulb socket. NOTE: Light
bulb removal and installation is similar to removing and
installing a standard automotive bulb.
Install new bulb by reversing the above procedure.
Reassemble all parts and tighten screws securely.
When electric tools are used on fiberglass boats, sports
cars, wallboard, spacWing compounds, or plaster, it has
been found that they are subject to accelerated wear and
possible premature failure, as the fiberglass chips and
grindings are highly abrasive to bearings, brushes,
commutator, etc. Consequently, it is not recommended that
this toot be used for extended work on any fiberglass material,
wallboard, spackling compounds, or plaster. During any
use on fiberglass it is extremely important that the tool is
cleaned frequently by blowing with an air jet.
WARNING: ALWAYS WEAR SAFETY GOGGLES
OR SAFETY GLASSES WITH SIDE SHIELDS
DURING POV/ER TOOL OPERATION OR WHEN
BLOWING DUST, IF OPERATION IS DUSTY ALSO
WEAR A DUST MASK.
PROPER CARE OF COLLET
From time to time, it also becomes necessary to clean your
collet and collet nut. To do so, simply remove collet nut from
collet and clean the dust and chips that have collected. Then
return collet nut to its original position.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrica
tion is required.
Page 11