Sears P/N93SR-D02 - Manual (Page 10)

AVOID SERVICE CHECKLIST (continued)
orn JRRFNCF
\_y V—V—<1 \~J 1 \ J V JL-rfl V—• 3Lmf
POSSIBLE CAUSE SOLUTION
Dirty air filter-air restricted. clean air filter.
Thermostat set too cool
(higher number)
Turn thermostat
counterclockwise to warmer
setting {lower number).
Exhaust vent control set at
OPEN/EXHAUST position. Set control to CLOSED position
for maximum heating.
Air directional louvers
positioned improperly. Position louvers for better air
distribution.
Front of unit is blocked by
drapes, blinds, furniture, etc.-
restricts air distribution. Clear blockage in front of unit.
Doors, windows, registers,
etc. open-hot air escapes:
cold air enters. Close doors, windows,
registers, etc
Unit recently turned on in
cool room.
Allow additional time to heat
walls, ceiling, floor and furniture.
Insufficient heating capacity
for area to be heated. Reconfirm the required heating
capacity with your dealer.
Air conditioner heating but
room too cool (some models
only).
10