Sears 385. 12714 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 2. PREPARE THE MACHINE FOR SEWING
Prepare the Top Thread
o Thread the Needle
The numbered steps above follow the numbers
on the illustrations.
Dotted lines show places where the thread
loops and then is pulled tight.
2
.
3.
4.
5.
While holding thread near spool, draw thread down into the tension area and then around the
check spring holder.
Firmly draw thread up and through take-up lever from right to left.
Draw thread down and slip it into left side needle bar thread guide.
Thread needle from front to back.
NOTE; You may want to cut the end of thread with sharp scissors for easier needle threading.
11
This manual is related to the following products: