Before starting the cleaning system, Add engine oil, Add gasc^ine – Sears 580.768050 User Manual
Page 8: To start the cleaning system
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BEFORE STARTING THE CLEANING
SYSTEM
To operate the
you wilt need to do the following:
Add Engine Oil
Only use high quality detergent oil rated with API
service classification SF or SG. Select the oil’s SAE
viscosity grade according to your expected operating
temperature:
colder
m
32°F
' » warmer
5W30
SAE30
Although multi-viscosity oils (5W30,10W30, etc.)
improve starting in cold weather, these multi-viscosity
oils will result in increased oil consumption when used
above
32°F. Check your engine oil level more
frequently to avoid possible damage from running low
on oil.
■ Place cleaning system on a level surface
■ Clean area around oil fill cap and remove.
■ Pour oil from enclosed bottle into the oii fill opening
until oil reaches the point of overflowing. Do not
overfill.
•
Install oil fill cap. Hand tighten securely.
Add Gasc^ine
•
Use regular unleaded gasoline with the cleaning
system engine. Fuel tank capacity is 1 gallon.
DANGER: Never fill fuel tank indoors. Never fill
fuel tank when engine is ninning or hot. Do not
smoke when filling fuel tank.
A
A
To add fuel to engine:
•
Clean area around fuel cap, remove cap.
• Add regular unleaded gasoline, slowly, to the fuel
tank.
Important: Never mix oil with gasoline.
•
Install fuel cap and wipe up any spilled gasoline.
TO START THE CLEANING SYSTEM
The best way to start your cleaning system engine for
the first time is to follow these instructions step-by
step. This starting information also applies whenever
you start the engine after you have let the cleaning
system sit idle for at least a day.
■ Place the cleaning system In an area close enough
to an outside water source that can flow at a rate of
at least 3 gallons per minute. Connect a garden
hose to the water spout.
• Check that the high pressure hose is tightly
connected to the spray gun and to the pump. See
ASSEMBLY section on page 4.
• Check inlet screen on the water inlet, if the screen
is dirty, clean before attaching a garden hose. If the
screen is damaged, do not connect to the garden
hose. Replace with screen provided In maintenance
kit or call 1-800-366-PART to order a replacement
inlet screen.
• Attach the the garden hose to the water Inlet.
• Turn on the water.
CAUTIONrDo not run pump without the water
supply connected and turned on. You must
follow this caution or the pump will be damaged.
Remove the dual lance from the spray gun.
Pull the trigger on the spray gun and hold until a
steady stream of water appears.
Engage the safety latch on the spray gun.
CAUTION: Do not overfill the fuel tank. Always
leave room for expansion.
CAUTION: Experience indicates that alcohol
blended fuels (called gasohol or using ethanol
or methanol) can attract moisture which leads to
separation and formation of acids during
storage. Acidic gas can damage the fuel system
of an engine while In storage.