Sears 580.768050 - Manual (Page 4)

ASSEMBLY
CARTON CONTENTS
The following parts are shipped loose with your
cleaning system;
• Main Unit — cleaning system with wheels,
chemical tanks, guide handle.
• High Pressure Hose (already attached to pump)
• Parts Box (which includes items listed below)
• Spray Gun
• Dual Lance with quick connect nozzle fitting
• Engine Oil
• Three-pack of chemical concentrates
• Four multi-colored nozzles
• Manual Bag (which includes the items listed
below)
• Owner’s Manual
• Nozzle Cleaner Kit
• “O’-RingKit
• Tank Labels
Become familiar with each piece before assembling
the cleaning system. Check all contents agairtst the
illustration on Page 5. If any parts are missing or
damaged, call the Pressure Washer Helpline at
1-800-222-3136.
TO REMOVE CLEANING SYSTEM FROM
CARTON
• Remove loose parts and parts box included with
your cleaning system.
• Slice two comers at guide handle end of carton
from top to bottom so the panel can be folded
down flat.
Lift the handle to
upright position and
siide the locking
caps into place
• Raise guide handle, secure in place.
• Roll the cleaning system out the open end of the
carton.
• Check carton for additional loose parts.
HOW TO SET UP YOUR CLEANING
SYSTEM
For the most part, your Craftsman High Pressure
Cleaning System has been assembied at the factory.
You must, however, assemble the spray gun, £uid
attach the high pressure hose to frie ^ray gun.
• Cut the tie wraps on the high pressure hose and
connect high pressure hose to gun. Tighten by hand.
Attach dual lance to spray gun.
Place assembled spray gun on holder.