Sears 580.768050 - Manual (Page 6)

HOW TO USE YOUR CLEANING SYSTEM
Read these instructions and team how to use your
cleaning system before you attempt to start your
cleaning system. If you have any problems operating
your cleaning system, please call the pressure washer
helpline at 1-800-222-3136.
How To Use the Nozzles
DANGER: Never exchange nozzles without
locking the safety latch on the trigger.
The quick-connect on the dual lance allows you
switch between four different nozzles. The nozzles
vary the spray pattern of the high pressure stream as
shown below.
White Green
40'
25'
Yellow Red
15'
0'
In order to change the nozzle being used, follow these
instructions:
• Engage the safety latch on the spray gun.
Pull back the cottar on the quick connect and pull
the current nozzle off: Store the nozzle in the space
provided on the control panel.
Note: For a more gentle rinse, select the 40“ or 25“
degree nozzle. To scour the surface, select the 15“ or
0“ nozzle.
• Pull back the collar, insert the new nozzle and
release the collar, making sure it becomes flush
with the end of the quick connect. Pull on the
nozzle to make sure it is securely in place.
Note: The chemical nozzle is permanently affixed to
your dual lance and has a spray pattern of 25
degrees. It must be used when appl^ng chemical.
• For most effective cleaning, keep spray nozzle
between 8 to 24 inches away from cleaning '
surface.
• Damage to the surface may occur if you get the
spray nozzle too close to it.
Cleaning With The Ntszles and Applying
Chmiical
A WARNING: You must attach all hoses before
you start the engine. Starting the engine without
all the hoses connected and without the water
turned ON will damage the pump.
IMPORTANT: Use soaps designed specifically for
pressure washer cleaning systems. Household
detergents could damage the pump.
Up to three (3) different solutions can be carried on the
cleaning system at one time. To apply detergent follow
these steps:
• Dilution is necessary when using the supplied
chemical packets. Simply snip one comer of the
plastic pouch, pour the chemical into the tank, then
fill the tank with clean water. Label tanks with the
provided tank labels.
Pour chemical into one of
the tanks labeled A, B, C.