Attaching the shift rod, Attaching the traction drive cable – Sears 247 886510 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ATTACHING THE SHIFT ROD
1.
Place the threaded end of the shift rod inside the
------ back cover plate. See figure 9. Thread rod part
way into ferrule.
2. Place the speed select lever in sixth speed (6) posi-
—^tion. See figure 10. Push the shift rod down as far
as it will go, to put the gears into full forward posi
tion. Thread the shift rod in or out of the ferrule as
necessary until the end of the rod lines up with the
hole in the speed select lever.
Insert end of rod into hole in speed select lever.
Secure with hairpin clip. See figure 10.
3.
ATTACHING THE TRACTION DRIVE CABLE
The traction drive cable is the cable which has the
spring attached to one end. Attach the traction drive
cable as follows.
1.---- Hook the “Z” fitting on the end of the cable into
top hole in the traction drive clutch lever (right hand
side oLhandle). Hook the fitting from the inside as
------ shown in figure 11.