Sears 113.244530 - Manual (Page 8)

assembly
An alternate method of mounting is to fasten band
saw to a mounting board. The board should be of suf­
ficient size to avoid tipping of saw while in use. Any
good grade of plywood or chipboard with a 3/4" mini­
mum thickness is recommended. (Thinner chipboard
can break.) Once the saw is mounted, securely clamp
the board to the workbench using “C” clamps.
WARNING: Supporting surface where band saw
is mounted should be examined carefully after
mounting to insure that no movement during
use can result. If any tipping or walking is noted,
secure workbench or supporting
surface before operating band saw.
INSTALLING THE TABLE
1. Loosen the upper slide lock knob and position the
upper guide assembly all of the way up. Tighten
lock knob.
Upper Slide
Lock Knob
Upper
Guide
Assembiy
2. Open the front cover of the saw by pulling forward
on the finger hold located on the left side of the
band saw.
Finger
Hold
=l_f Table
Assembly
3. Locate the square hole behind the lower right
wheel and insert a 1/4-28 x 1" long carriage bolt
through this hole from inside the saw.
4. Position the table-trunnion assembly on the back
side of the saw so the 1/4-28 x 1" bolt extends
through the curved slot in the trunnion. The trun­
nion should engage the curved mounting rib on the
back side of the saw.
-
5. Install the 1 " outside diameter washer and table
lock knob to the end of the bolt and tighten by
hand.
Trunnion
Trunnion Slots
Table Lock
Knob