Sears 113.244530 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/718358/6/background.png)
contents
POWER TOOL WARRANTY............................................2
SAFETY INSTRUCTIONS FOR BAND SAW...................2
GLOSSARY OF TERMS FOR WOODWORKING............. 4
MOTOR SPECIFICATIONS AND ELECTRICAL
REQUIREMENTS.........................................................5
UNPACKING AND CHECKING CONTENTS...................
ASSEMBLY
Mounting Band Saw to Workbench.......................... 7
Installing the Table.....................................................
Installing the Blade.....................................................9
Tensioning the Blade................................................10
Tracking the Blade.................................................. 11
Adjusting the Blade Guides and
Back-Up Bearing..................................................
11
Final Table Assembly.............................................. 12
Aligning the Table Square to the Blade................. 12
Getting to Know your Band Saw............................ 14
BASIC BAND SAW OPERATION................................. 16
MAINTENANCE............................................................. 19
RECOMMENDED ACCESSORIES............................... 19
TROUBLESHOOTING................................................... 20
REPAIR PARTS............................................................ 21
unpacking and checking contents
TOOLS NEEDED
■ I ■ 1 ■ I ■ ............................ ................................ I ■ 1 . I I
COMBINATION SQUARE l(
#2 PHILLIPS SCREWDRIVER
MEDIUM SCREWDRIVER
=3
1/2 INCH WRENCH
WARNING: To avoid injury from unexpected
starting or electrical shock, do not plug the saw
in until all assembly and alignment steps are
complete.
The
power
cord
must
remain
unplugged whenever you are working
on the saw.
Model 113.244530 Band Saw is shipped complete in
one carton.
Separate all parts from packing materials and check
each item with illustration and “Table of Loose Parts”.
Make certain all items are accounted for, before dis
carding any packing material.
COMBINATION SQUARE MUST BE TRUE
DRAW-LIGHT
LINE ON BOARD
STRAIGHT EDGE OF
BOARD 3/4' THICK
THIS EDGE MUST BE
^
/
THIS EDGE MUST BE
/
PERFECTLY STRAIGHT
SHOULD BE NO GAP OR OVERLAP HERE WHEN
SQUARE IS FLIPPED OVER IN DOTTED POSITION
WARNING: If any parts are missing, do not try to
assemble the band saw, plug in the power cord,
or turn the switch on until the missing parts are
obtained and instailed correctly.