Sears 113.244530 - Manual (Page 7)

ITEM TABLE OF LOOSE PARTS QTY.
A Basic saw assembly............................. 1
B Owners Manual...................................... 1
C Loose Parts Bag
Containing the following parts:
Wing Nut 1/4-20 x 5/8............................ 1
Screw, Truss Hd. 1/4-20........................ 1
Wrench, Hex “L” 1/8.............................. 1
Bevel Indicator...................................... 1
Screw, Pan Cross 10-32 x 3/8.............. 1
Washer 17/64 X 1 x 1/16........................ 1
Bolt, Carriage 1/4-28 x 1 ....................... 1
Knob....................................................... 1
Clip Hose............................................... 1
D Saw Table.............................................. 1
assembly
MOUNTING BAND SAW TO WORKBENCH
If band saw is to be used in a permanent location, it
should be fastened securely to a firm supporting sur­
face such as a workbench.
If mounting to a workbench, holes should be drilled
through supporting surface of the workbench using
dimensions illustrated.
1. Each leg should be bolted securely using 5/16"
diameter machine screws, lockwashers, and 5/16"
hex nuts (not included). Screw length should be
1 -3/4" plus the thickness of the bench top.
2. Locate and mark the holes where band saw is to
be mounted.
3. Drill (4) 3/8" diameter holes through workbench.
4. Place band saw on workbench aligning holes in
feet with holes drilled in workbench.
5. Insert all four 5/16" screws and tighten.
NOTE: All bolts should be inserted from the top.
Install the washers and nuts from the underside of the
bench.
5”
3/8" DIAMETER
(4) HOLES
t ir-
CLAMPING BANDSAW TO WORKBENCH
The Band Saw can be clamped directly to a work­
bench using two (2) or more “C” clamps on base of
unit.
C” Clamp
“C” Clamp
Workbench