Sears 917.258552 - Manual (Page 15)

OPERATION
MOWING TIPS
® Tire chains cannot be used when the mower housing is
attached to tractor.
• Mower shouW be property ieveled for best mowing
performance. See ‘TO LEVEL MOWER HOUSING" in
the Service and Ad|ustments section of this manual.
® The left hand side of mower should be used for trim­
ming.
» Drive so that clippings are discharged onto the area
that has been cut. Have the cut area to the right of the
tractor. This will result in a more even distribution of
clippings and more uniform cutting.
• When mowing large areas, start by turning to the right
so that clippings will discharge away from shrubs,
fences, driveways, etc. After one or two rounds, mow
in the opposite direction making left hand turns until
finished (See Fig. 12A ),
• If grass is extremely tall, it should be mowed twice to
reduce load and possible fire hazard from dried dip­
pings. Make first cut relatively high; the second to the
desired height.
• Do not mow grass when it is wet. Wet grass will plug
mower and leave undesirable clumps. Allow grass to
dry before mowing,
» Always operate engine at lull throttle when mowing to
assure better mowing performance and proper dis­
charge of material. Regulate ground speed by select­
ing a low enough gear to give the mower cutting
performance as well as the quality of cut desired.
' When operating attachments, select a ground speed
that will suit the terrain and give best performance of
the attachment being used.
IJULCHiNG MOWING TIPS
IMPORTAflT: FOR BEST PERFORMANCE KEEP
MOWER HOUSING FREE OF BUILT-UP GRASS AND
TRASH. CLEAN AFTER EACH USE.
® The special muiching blade wifi recut the grass clip­
pings many times and reduce them in size so that as
they fail onto the iawn they will disperse into the grass
and not be noticed. Also, the mulched grass will
biodegrade quickly to provide nutrients for the lawn.
Always mulch with your highest engine (blade) speed
as this will provide the best recutting action of the
blades.
® Avoid cutting your lawn when it is wet. Wet grass tends
to form clumps and interferes with the mulching action.
The best lime to mow your (awn is the early afternoon.
At this lime the grass has dried and the newly cut area
will not be exposed to the direct sun.
.
* For best results, adjustthe mower cutting height so that
the mower cuts off only the top one-third of the grass
blades (See Fig. 12B). For extremely heavy mulching,
reduce your width of cut and mow slowly.
® Certain types of grass and grass conditions may re­
quire that an area be mulched a second time to com-
pleteiy hide the clippings. When doing
a second cut.
mow across or perpendicular to the first cut path.
• Change your cutting pattern from week to week. Mow
north to south one week then change to east to west the
next week. This will help prevent matting and graining
of the iawn.
FIG. 12B
15