Sears 919.329150 - Manual (Page 10)

A CAUTION
Read owners manual. Do not attempt to operate equipment until you have mad Owners
Manual tor Safety, Aasembly, Operation, Malntwiance, Storage Instructions.
TOOLS NEEDED FOR ASSEMBLY
1 - Box Cutter or Knife
2 - 9/16 “ Wrenoties
2 -1/2" Wrenches
1 -1 " thick X1 ' square piece of wood
REMOVE GENERATOR FROM CARTON
* Open carton from top.
* Cut carton along dotted lines.
■ Remove ali carton inserts.
* Remove generator through opening in carton.
* Using a 9/16 inch socket remove the two shipping
blocks from under the generator head. Unscrew
the bolts and remove the wood blocks. NOTE: It
is very Important that these are removed before
startirtg your generator.
IMPORTANT^ Before any attempt to start your genera­
tor ba sure to check engine oil (See Adcfing Engine Oil
paragraph in the Operation section on page 14 of this
ntanual.)
INSTALLATION OP BATTERY
Recommended Battery for Electric Start: 12V - 45 A H.
or 210 CCA (Cold Cranking /Vmps)
Purchase battery end battery hardware separately, not
included with unit.
• Place battery in rack with terminals facing towards
generator head.
• Place battery bracket (A) over battery as shown
(opposite battery terminals).
Place 'L* bolt (B) through top and bottom brack­
ets and seoure with wing nut (C).
Locate the solenoid on the left side of the unit.
Solenoid
Lawn A Garden batteries ACAUTION
can come in two terminal configurations. The
Posttive (+) and Negat^ (-) terminals can be
oriented so that they are +/• or In №e
unlikely event that tt» baitwy terminals me
unmarked, we recommend that you return the
battery to the retailer for exchange for a prop­
erly marked battery or let an authorized service
center install tts battery for you. Failure to
connect the battery preparfy can possibly
cause bodily injury. In addition, extensive
engine electrical damage not be covered under
warranty can result.
□ — -e- —► -i- [D
1 1 - 1
AWARNING
I lb Prevent sparks eonnsct
the rad (positnre) cable to tiie positive {+)
terminal before cenneeting the black iwgative
crtrle.
Remove the nut from the solenoid post dosest to
the engirw. Place one end of the positive (red)
battery cable onto the post. Reassemble nut and
tighten securely.
Slide protective cover over solenoid post.
SeleneM
Attach the other end of the positive |
cable to the positive {+) terminal on the battery.
10 ~ eng