Initial adjustments – Sears 917.255741 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
W»NG
4,
install Battery using: two Int./E'xt. Lockwashers.-two Wing
Nuts (shown full size below) and
Q-Q
i—m:
---------------f-....—....
1
-------------- —----------------------------
_______________________ d.
two Battery Bolts and one Terminal Guard found in Bag of
Parts.
a. Using the slot on one side of the Battery Support (Fig.
6A) slide Battery Bolt into Frame Slot (head of Bolt
down). Fasten the Battery Bolt to the Terminal Guard
using Int/Ext Lockwasher and Wing Nut as shown in
Fig. 6A.
b. Assemble the remaining Battery Bolt to other side of
Battery Support and fasten Terminal Guard to it with re
maining lnt./Ext Lockwasher and Wing Nut Tighten
Wing Nuts securely by hand (Fig. 6A).
NOTE: USE TERMINAL ACCESS DOORS (FIG.6A) FOR:
1. Inspection for secure connections (tighten hardware).
2. Inspection for corrosion.
3. Testing battery.
4. Jumping (if required).
5. Charging (if required).
A
WHEN
NOT
IN
USE.
KEEP
TERMINAL
ACCESS DOORS CLOSED,
NOTE; DO NOT START ENGINE UNTIL INITIAL SER
VICE HAS BEEN PERFORMED-
INITIAL ADJUSTMENTS
1. TIRE PRESSURE
Reduce Tire pressure to 14 PSI in front tires; 12 PSI in
rear tires. (Tires were overinflated for shipping).
2. HOOD
a. To raise Hood, lift at rear of Hood.
b. Unsnap Headlight Connection (Fig. 8).
To remove Hood, Grill and Side Panels, raise Hood and
loosen one screw on each Side Panel. (The screw remains
in the Side Panel) (Fig. 7)
Stand in front of Tractor. Grasp Hood and tilt forward
and lift off (Fig. 8).
e.
To reinstall, reverse above procedure.
c.
d.